Wiring
6.8 Front connector for the I/O modules
ET 200MP Distributed I/O System
70
System Manual, 01/2013, A5E03723484-01
7.
Wire the power supply element (Figure 8).
Terminals 41/42 and 43/44 are galvanically connected to each other. If you connect the
supply voltage to 41 (L+) and 44 (M), then with terminals 42 (L+) and 43 (M) you can loop
the potential to the next module.
'&9
/
0
Wiring front connectors for I/O modules with shield contact element
1.
Begin to completely wire the front connector (Figure 1).
2.
Strip the cable shielding.
Summary of Contents for simatic ET 200MP
Page 4: ...Preface ET 200MP Distributed I O System 4 System Manual 01 2013 A5E03723484 01 ...
Page 8: ...Table of contents ET 200MP Distributed I O System 8 System Manual 01 2013 A5E03723484 01 ...
Page 118: ...Service Support ET 200MP Distributed I O System 118 System Manual 01 2013 A5E03723484 01 ...
Page 126: ...Index ET 200MP Distributed I O System 126 System Manual 01 2013 A5E03723484 01 ...
