Installation
5.5 Installing I/O modules
ET 200MP Distributed I/O System
48
System Manual, 01/2013, A5E03723484-01
5.5
Installing I/O modules
Introduction
The I/O modules are installed following the interface module. The I/O modules form the
interface between the controller and the process. The controller detects the current process
state via the connected sensors and actuators, and triggers the corresponding reactions.
Requirements
The mounting rail is installed.
The interface module is installed.
The module located before the I/O module has a U connector inserted at back right.
Tools required
Screwdriver with 4.5 mm blade
Installing I/O modules
Watch video sequen)
1.
Place the U connector at the back right of the interface module (see following picture).
Exception: the last I/O module in the assembly.
2.
Install the I/O module on the mounting rail
3.
Pivot the I/O module towards the back
Figure 5-6
Installing I/O module
4.
Fasten the I/O module (torque 1.5 Nm)
Summary of Contents for simatic ET 200MP
Page 4: ...Preface ET 200MP Distributed I O System 4 System Manual 01 2013 A5E03723484 01 ...
Page 8: ...Table of contents ET 200MP Distributed I O System 8 System Manual 01 2013 A5E03723484 01 ...
Page 118: ...Service Support ET 200MP Distributed I O System 118 System Manual 01 2013 A5E03723484 01 ...
Page 126: ...Index ET 200MP Distributed I O System 126 System Manual 01 2013 A5E03723484 01 ...
