Siemens SIMATIC ET 200eco, Manual

Page: 80 / 124

Technical data
6-2
ET 200eco Distributed I/O Station
A5E00158716-02
6.1 ECOFAST terminal block (6ES7 194-3AA00-0AA0)
Properties
Characteristics of the ECOFAST terminal block:
•
Can be plugged in and screwed on to any I/O module.
•
Connection to power supplies and PROFIBUS DP via ECOFAST connector (at
socket X01, supply lines).
•
Looping the power bus and PROFIBUS DP to the next PROFIBUS node via
additional ECOFAST connector (at socket X02, loop–through).
•
Internally interconnected supply line socket X01 and loop–through socket X02
(T functionality).
•
Adjustable PROFIBUS address (1 to 99) via configuration plug.
Note
The ECOFAST terminal block may only be operated with the I/O modules
6ES7 14*-3B*00-0XA0.
Pin assignment of the ECOFAST sockets
The table below shows the pin assignment of the two ECOFAST sockets for the
connection to the power supplies and PROFIBUS DP.
Table 6-1 Pin-out of the sockets X01 and X02
Pin Assignment of the
infeed socket X01
Assignment of the
through–loop socket
X02
View of the socket (Front
view of the terminal
blocks)
A PROFIBUS DP Signal A
B PROFIBUS DP Signal B
A B
1 Electronic/sensor power supply (1L+)
A B
2 Ground potential, sensor power supply (1M)
1
2 3
4
3 Ground potential, load voltage supply (2M)
4 Load voltage supply (2L+)