Siemens SIGMASYS C, Manual

Page: 56 / 138

8 Transponders and loop elements
48 / 128 BMT Project Planning Guidelines
Best.Nr. A24205-A337-B970 – Edition 12 (03/07)
The following data applies:
; >4.3 k Ω
ance 560 Ω – 680 Ω
Termination with 3.3 k Ω (normal open NO)
to 4.2 s played. See “Cycle times for
Fault, short circuit, wire breakage: <300 Ohm
Alarm: Alarm resist
Idle:
The signal must last for at least 1.4 econds for it to be dis
signals”.
Installation
The contact coupler SPF 5300 can be installed on a 15 mm top-hat rail in the space provided
for option equipment in the control and indicating panel or in a distribution cabinet (AP…).
8.2.5 E gateway SIGMASPAC
The gateway radio is a loop element which can administer up to 30 radio components inside
a radio cell (spatial area). From the perspective of SIGMALOOP, the gateway is the same as
a transponder that occupies a separate address for itself and each radio component.
Concept
•
similar to transponder
•
occupies a variable number of address elements depending on the number of radio
components used: up to 31, the gateway occupies a loop address. Max. number on
loop see chapter Load factors" on page 84.
s to SIGMASYS control and indi-
SYS detector base SPF 3600.
entation in the standard collection are to be used for
cell”, A24205-A337-A910.
There are two radio gateways for connecting radio detector
cating panels.
•
SPU6102 gateway in the housing
•
SPU6100 gateway as intermediate ring for SIGMA
The radio gateways connect the radio detector DOW 1171 to SIGMALOOP.
The SIGMASPACE hybrid system docum
project planning, “Project planning a radio
8.2.6 Zone operating panel SPF 3300
The SIGMASYS zone operating panel is an operating and display element for all SIGMASYS
control and indicating panels. It requires an address as an element for the SIGMALOOP
transmission procedure.
n be assigned and are freely programmable.
d to one zone operating panel.
•
Disablement
57 texts with 16 characters each ca
The first event is displayed. The others can be viewed by scrolling.
Events can only be sent by the MPC to which the zone operating panel is connected. An
event can only be assigne
Technical signals are displayed as alarms. Detector numbers are not displayed.
The detector type is displayed in line 1 depending on the priority:
•
Alarm
•
Fault