Product Features Description
Sicore II Installation and Commissioning Guide
667/HB/52600/000 Issue 2 Unrestricted
23
4.6.5.
System Log
Important events are recorded in the System Log. The source of the event with the date and
time at which the event occurred is recorded along with an indication of its severity:
Error
Notice
Warning
Information
With the default logging level configuration, only events with severity level of
Notice and
Error are recorded in the System Log. Enabling the Warning and Information level of
logging is an advanced option not covered in this handbook (refer to Siemens Plc Support
Personnel).
4.6.6.
System
The System tab shows the user the software build status of the camera. The camera is based
around a Linux operating system along with various software applications providing the
cameras’ functionality. The applications and their versions are displayed on this page
along with the ability to ‘Export Site Information’ which will generate a zip file containing
all of the available system logs.
At the bottom of the page there are two buttons:
Reboot System – This allows the user to remotely reboot the system. (Note that this restarts
the camera Application Software but not the underlying Operation System)
Wipe System – This provides a complete Factory Reset of the Camera configuration. The
system wipe should not be performed remotely because it will revert the camera to
factory default settings, including all network settings. The following warning is
displayed if this option is selected:
Figure 2 – Wipe System Warning
Note that, although Sicore II comes out of the factory with a fixed IP address (see section
1.7), use of the ‘Wipe System’ function will reset the network configuration to DHCP mode.