Installation and mounting
5.5 Setting up the charging station
SICHARGE D
58
Operating Instructions, 02/2021, 8EM5907-0AA00-1AA7.01
5.5
Setting up the charging station
Note
Secure and clear communication between the crane or forklift driver and the installer must be
guaranteed while the charging station is being positioned and set up.
5.5.1
Preparing cables
Prepare all required conductors and connections before you start positioning the charging
station on the foundation.
Preparing the conductors of the power supply cable
To connect the individual wires correctly, you need to prepare the individual conductors of
the power supply cable. Proceed as follows:
1.
Shorten the cables to a length that enables you to easily insert them into the charging
station. Note the exact position of the AC cable entry on the front of the charging station.
2.
Remove the sheath from the AC cables.
3.
Protect the individual conductors properly from environmental influences such as dirt and
moisture.
Preparing the network cable
The charging station offers the possibility of connection to the network via an Ethernet cable.
Ensure proper protection of the cable from environmental impacts such as dirt and moisture.
Read the information on laying in section 5.3 (Page 54).
Preparing dispenser cables
If dispensers are to be connected to the charging station, proceed as follows:
1.
Shorten the cables to a length that enables you to easily insert them into the charging
station. Also note the exact position of the cable entry for the DC cables on the back of the
charging station.
2.
Remove the sheath of the DC cables.
3.
Protect the individual conductors properly from environmental influences such as dirt and
moisture.
In addition to the power connections, the dispensers require an auxiliary power supply,
communication lines and integration into the control system of the charging station. Lay
these cables separately from the power cables. Ensure proper protection of the cables from
environmental effects such as dirt and moisture.
