Siemens SICAM CMIC, User Manual

Page: 142 / 414

Engineering via SICAM WEB
142
SICAM RTUs, User Manual SICAM CMIC
DC8-001-2.09, Edition 08.2016
5.1.2.4 Set IP Addresses
The settings of the IP addresses reside in the directory tree under
SICAM CMIC | Master module | Network settings | IP address .
With engineering in a network (company intranet, networked plant), conformable IP addresses
must be assigned. The IP address for the web server of your target devices can be changed
with the parameter
Own IP address
.
Note
The IP settings depend on the configuration and the used transmission media of your network. For the
setting of these parameters please contact your network administrator.
The details for the setting of the advanced parameters for secure network configurations can be found in
the
SICAM RTUs • SICAM TOOLBOX II Administrator Security Manual .
By default, the interfaces X1 and X4 are assigned to the same IP address (parameter
Mode
of ethernet ports
= 1 IP address (connected ports in switch mode) ), optionally via
IPsec (VPN) selectable.
Note
The IP address set via SICAM WEB is only relevant without use of a DHCP server (parameter
Autoconfiguration
= NO ).
With use of a DHCP server SICAM CMIC receives the the IP address automatically. Further details see
5.1.2.5 , Autoconfiguration (restricted operation mode).
With the parameter
Mode of ethernet ports
= 2 IP addresses (independent ports) you
can define a second IP address for X4. Thereby the target device can be accessed also via
X4 independently of the network settings on X1, for instance
•
X1: process LAN
•
X2: office LAN
The server services of SICAM CMIC are attainable on both interfaces.
The further possibilities resulting thereout are described in Appendix F , Use Cases .