Siemens SENTRON, Manual

Page: 221 / 224

Manual, 08/2017, L1V30368969104A-02
221
ESD guidelines
B
In this chapter, you will find the ESD guidelines that must be observed when handling the
3KC4 and 3KC8 transfer switching equipment.
B.1 Electrostatic sensitive devices (ESD)
ESD components are destroyed by voltage and energy far below the limits of human
perception. Voltages of this kind occur as soon as a device or an assembly is touched by a
person who is not electrostatically discharged. ESD components which have been subject to
such voltage are usually not recognized immediately as being defective, because the
malfunction does not occur until after a longer period of operation.
ESD Guidelines
NOTICE
Electrostatic sensitive devices
Electronic modules contain components that can be destroyed by electrostatic discharge.
These modules can be easily destroyed or damaged by improper handling.
•
You must discharge your body electrostatically immediately before touching an
electronic component. To do this, touch a conductive, grounded object, e.g., a bare
metal part of a switch cabinet or the water pipe.
• Always hold the component by the plastic enclosure.
•
Electronic modules should not be brought into contact with electrically insulating
materials such as plastic film, plastic parts, insulating table supports or clothing made of
synthetic fibers.
• Always place electrostatic sensitive devices on conductive bases.
•
Always store and transport electronic modules or components in ESD-safe conductive
packaging, e.g. metallized plastic or metal containers. Leave the component in its
packaging until installation.
NOTICE
Storage and transport
If you have to store or transport the component in non-conductive packaging, you must first
pack the component in ESD-safe, conductive material, e.g., conductive foam rubber, ESD
bag.