Siemens SENTRON PAC2200CLP, Product Manual, Page: 62 / 130

Commissioning
6.3 Parameterizing the device
PAC2200CLP
60
Equipment Manual, 06/2021, L1V30820585B-02
6.3 Parameterizing the device
6.3.1 Parameterizing with powerconfig
You can download the powerconfig configuration software from the Industry Online Support
Website ( (https://support.industry.siemens.com/cs/ww/en/view/63452759) herunterladen. ).
Information and notes on how to use powerconfig can be found in the Online Help of the
configuration software or by contacting Technical Support.
You launch the Online Help in powerconfig by pressing the "F1" key.
Before you can configure the PAC2200CLP power monitoring device, the measuring voltages
must be connected and communication with the device must be set up.
Establishing a connection to PAC2200CLP
Proceed as follows to establish a connection to the PAC2200CLP device:
1.
Connect the PAC2200CLP device to the PC or network.
2. If you have connected the device via the Ethernet, make sure that the device and the
configuration computer are in the same subnet.
3. Open the powerconfig configuration software.
4. On the toolbar, click on the "Search for accessible devices" key or alternatively press the
"F11" key. The "Search for accessible devices" window is displayed.
5. Click the "Ethernet" tab in the "Search for accessible devices" window:
The "Ethernet" view appears.
– Select the Ethernet interface from the selection list.
– Click on the "Start search" button.
– Select the desired device.
– If necessary, adapt the communication settings.
– To do this, switch the edit mode to "Unlocked". Carry out the required settings in the
menu options "IP address", "Network mask", "Gateway" etc. Click on the button "Load
changes to configuration parameters into device(s)".
6. All devices found are shown in the "Result" window.
7. Select the desired device and click on the "Create devices" button.
The selected device is added.