Siemens SENTRON PAC2200CLP, Product Manual, Page: 113 / 130

Appendix
A.1 Modbus TCP
PAC2200CLP
Equipment Manual, 06/2021, L1V30820585B-02
111
Table A- 12 I&M 1-4 parameters with the function codes 0x03, 0x04 and 0x10
Offset Total regis-
ters
Number of
registers per
parameter
Name Format Value range Access
Start offset
64028
89 [16] Plant identifier Char 32 ASCII RW
[64044] [11] Location identifier Char 22 ASCII RW
[64055] [8] Installation date Char 16 ASCII RW
[64063] [27] Comment Char 54 ASCII RW
[64090] [27] Signature Char 54 - RW
A.1.11 Modbus command parameters
Addressing the command parameters
You can apply the Modbus function code 0x06 to the command parameters.
Table A- 13 Command parameters
Offset Number
of regis-
ters
Name Unit Format Value range Access
60006 1 Switching tariff - unsigned short 0 = Main tariff W
1 = Secondary
tariff
60007 1 Acknowledge the diagnostics
bits
3)
(cf. stored bits in un-
signed long beginning off-
set 205)
- unsigned short 0 ... ffffh W
60008 1 Switching outputs (if parame-
terized)
- unsigned short 0ffh ... 1ffh W
Byte 0
= 0
Digital output
0.0
Byte 1
= 0
OFF
Byte 1
= 1
ON
60009 1 Switching command for vector
group
- unsigned short High 0 ... 99, Low 0 ... 1
High byte group assign-
ment
Low byte 1 = ON, 0 = OFF
W
3) The Modbus Master must acknowledge these diagnostics bits.