Accessories
12.1 Expansion modules
3KC ATC6300 transfer control device
178
Manual, 03/2018, L1V30535632002A-01
12.1.1.1
Technical specifications
Power supply
Supply voltage
5 V DC (supplied through the ATC6300)
Current consumption (max.)
290 mA
Power loss (max.)
1.5 W
Digital inputs
Number of digital inputs
4
Input type
Positive or negative (depending on the connec-
tion of the control terminal COM)
Note: All inputs must have the same polarity
Input current
7 mA
Input signal - logical state "0"
≤
2 V (if COM is connected to -)
≥
22 V (if COM is connected to +)
Input signal - logical state "1"
≥
7.6 V (if COM is connected to -)
≤
12.4 V (if COM is connected to +)
Maximum frequency
2000 Hz (if the input is configured as a counter)
50 Hz (if input is configured as status)
Input signal delay
≥
50 ms
Connecting terminals
Removable / plug-in
Cable cross-section (min-max)
0.2 … 1.5 mm
2
(AWG 28 ... 14)
Tightening torque
0.18 Nm (1.7 lbf-in)
Control terminal COM and auxiliary supply ter and -
Auxiliary power supply at + and -
24 V DC (see tolerance graph in chapter Expan-
sion module 4DI (Page 176))
Maximum current at + and -
42 mA (protected against overload and short-
circuit)
Note: If the maximum current is exceeded, the
protection is enabled and the voltage drops
Connecting terminals
Removable / plug-in
Number of terminals
3
Cable cross-section (min-max)
0.2 … 2.5 mm
2
(AWG 24 ... 12)
Cable cross-section (min-max) acc. to UL 508
0.75 … 2.5 mm
2
(AWG 18 ... 12)
Tightening torque
0.5 Nm (4.5 lbf-in)
Insulation
Impulse withstand voltage U
imp
4 kV
Operating frequency impulse withstand voltage
2 kV
Ambient conditions
Operating temperature
-20 … +60 °C
Storage temperature
-30 … +80 °C
Relative humidity
< 80 % (IEC / EN 60068-2-70)
Maximum degree of pollution
2