NL Avoid material damage
m
Material damage
avoid
avoid material damage
s Modified or damaged water
hoses can lead to material damage
and damage to the device.
▶
Never kink water hoses,
pinch, modify or cut.
▶
Only supplied water hose
gen or use original spare hoses.
▶
Never used water hoses
reuse.
s Too low or too high water pressure
may interfere with the device function.
▶
Make sure the water pressure
at the water supply installation is
a minimum of 50 kPa (0.5 bar)
and a maximum of 1000 kPa (10
bar).
▶
When the water pressure reaches the
exceeds the given maximum
value, a pressure reducing valve
must be installed between the
drinking water connection and
the hose set of the unit.
Avoid material damage
Safe installation
PAY ATTENTION!
s An improper installation of
the device can cause damage.
▶
If the dishwasher is under or above
If other household appliances
are installed, the information on
installation in conjunction with
the dishwasher in the installation
instructions for the respective
household appliance must be
observed.
▶
If no information is available
or if the installation manual
does not contain any
instructions on this subject,
check with the manufacturer of
these household appliances
whether the dishwasher can be
built-in above or below other
household appliances.
▶
If there is no information from the fa-
brine is available, the
dishwasher must not be
installed above or below these
household appliances.
▶
To ensure safe operation of all
household appliances, you must
also follow the installation
instructions for the dishwasher.
▶
Do not place the dishwasher under a
install hob.
▶
Do not install the dishwasher in
near heat sources such as
radiators, water heaters, stoves,
or other appliances that give off
heat.
Safe use
PAY ATTENTION!
s Emerging water vapor
can damage built-in furniture.
▶
The device after the end of
allow the program to cool down
briefly before opening the
appliance door.
s The rinse aid container can be
corrode softening salt for
dishwashers.
▶
To ensure that
spills out of the softening salt
from the rinse aid container, the
softening salt must be filled into
the water softening salt
reservoir immediately before the
program starts.
10
