Siemens SCALANCE XM-400, Configuration Manual

Page: 87 / 960

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
87
Result
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder
$$$
is replaced by the following name of the interface:
Type of interface Command prompt
cpu0 cli(config-if-cpu0)#
vlan cli(config-if-vlan-$)#
port-channel cli(config-if-po-$)#
gigabitethernet cli(config-if-Gi$-$)#
extreme-ethernet cli(config-if-Ex$-$)#
The placeholders
$
or
$-$
denote the numbering of the interface.
The ranges of values for the logical interfaces VLAN and port channel can be found in the
table above. You can only call up interfaces that you created with the
vlan
or
channel-group
command.
The ranges of values from the physical interfaces depend on the hardware configuration.
Further notes
You exit the Interface configuration mode with the
end
or
exit
command.
You delete a logical interface with the
no interface
command.
You display the status and the configuration of the interfaces with the
show interfaces
command.
3.1.12.8 no interface
Description
With this command, you delete a logical interface.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no interface{vlan<vlan-id(1-4094)>|port-channel<port-channel-id(1-8)>}