
Security and authentication
11.4 IP access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
836
Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip access-list standard<access-list-number(1-128)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
standard
Specifies that a standard access con-
trol list is generated
-
access-list-number
Number of the standard access control
list
1 ... 128
Result
The access control list is deleted.
Further notes
You generate an IP access control list with the
ip access-list
command.
You display the configuration of the access control list with the
show access-lists
command.
11.4.3
Commands in the Interface Configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface
command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
●
If you exit the Interface configuration mode with the
exit
command, you return to the
Global configuration mode.
●
If you exit the Interface configuration mode with the
end
command, you return to the
Privileged EXEC mode.
Summary of Contents for SCALANCE XM-400
Page 882: ......