Siemens SCALANCE XM-400, Configuration Manual

Page: 712 / 960

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
712
Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Parameter Description Range of values / note
name
Name of the route map 0 … 20
seqnum
Sequence number of the route map 1 … 10
Result
The route map has been deleted.
Further notes
You create a route map and change to the Route maps configuration mode with the
command
route-map
.
You display the setting and other information with the
show route-map
command.
9.8.3 Commands in the Route maps configuration mode
This section describes commands that you can call up in the Route maps configuration
mode.
In the global configuration mode, enter the
route-map
command to change to this mode.
● If you exit the Route maps configuration mode with the
exit
command, you return to the
global configuration mode.
● If you exit the Route maps Configuration mode with the
end
command, you return to the
Privileged EXEC mode.
9.8.3.1 match destination ip
Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the destination IPv4 address.
Note
This command is available only with layer 3 (IPv4).
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#