Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
677
9.6.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal
command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end
or
exit
command and are then in the
Privileged EXEC mode again.
Note
These commands are available only with layer 3.
9.6.2.1
router rip
Description
With this command, you enable the RIP protocol and change to the Router configuration
mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
router rip
Result
Routing with RIP is enabled.
You are now in the Router configuration mode.
The command prompt is as follows:
cli (config-rip)#
Further notes
You disable the RIP protocol with the
no router rip
command.
Summary of Contents for SCALANCE XM-400
Page 882: ......
