Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
533
Parameter
Description
Range of values / note
md5
Keyword for the password
-
key
Password
enter the password
Maximum length:
16
characters
Result
The virtual link is created.
Further notes
You delete the virtual link with the
no area virtual link
command.
You display information about the virtual link with the
show ip ospf virtual
command.
9.2.3.10
no area virtual-link
Description
With this command, you delete a virtual link.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no area <area-id> virtual-link <router-id>
[authentication]
[hello-interval]
[retransmit-interval]
[transmit-delay]
[dead-interval
[{
authentication-key | message-digest-key <Key-id (0-255)>
}]
Summary of Contents for SCALANCE XM-400
Page 882: ......
