Layer 2 management protocols
8.6 Unicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
488
Configuration Manual, 06/2016, C79000-G8976-C252-11
8.6.1.3
show mac-address-table static unicast
Description
This command shows the table with the static unicast MAC addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
or
cli#
Syntax
Call up the command with the following parameters:
show mac-address-table static unicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN connection
-
vlan-range
Number of the addressed VLAN
1 ... 4094
address
Keyword for a MAC address
-
aa:aa:aa:aa:aa:aa
MAC address
-
interface
Keyword for a an interface description
-
interface-type
Type or speed of the interface
Enter a valid interface
interface-id
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The static unicast MAC addresses are displayed.
8.6.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal
command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end
or
exit
command and are then in the
Privileged EXEC mode again.
Summary of Contents for SCALANCE XM-400
Page 882: ......
