Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
312
Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
●
The neighbor node is located on the same link.
●
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ipv6 neighbor <prefix>
{vlan <id> | [<interface-type> <interface-id>]}
<MAC ADDRESS (xx:xx:xx:xx:xx:xx)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
prefix
IPv6 address of the neighbor node
Enter a valid IPv6 address.
vlan
Keyword for a VLAN connection
-
id
Number of the addressed VLAN
1 ... 4094
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
MAC ADDRESS
Link layer address (MAC address) of the neighbor node
xx:xx:xx:xx:xx:xx
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The entry is deleted.
Further notes
You configure an entry with the
no ipv6 neighbor
command.
You display the IPv6 neighbor table with the
show ipv6 neighbors
command.
7.2.3.3
ipv6 path mtu
Description
With this command, you configure maximum packet size (MTU). The setting is only effective
if PMTU Discovery is enabled.
Summary of Contents for SCALANCE XM-400
Page 882: ......
