Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
232
Configuration Manual, 06/2016, C79000-G8976-C252-11
6.2.3
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface
command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
●
If you exit the Interface configuration mode with the
exit
command, you return to the
Global configuration mode.
●
If you exit the Interface configuration mode with the
end
command, you return to the
Privileged EXEC mode.
6.2.3.1
channel-group
Description
With this command, you add an interface to an Etherchannel.
Requirement
With the
interface po <channel-group-id(1-8)>
command, you have already generated a
logical interface for an Etherchannel.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
channel-group <channel-group-number(1-8)> mode{on|active|passive}
The parameters have the following meaning:
Parameter
Description
Range of values / note
channel-group-
number
Number of the Channel-Group
1 … 8
on
Adds the interface without LACP to a
Channel-Group.
This corresponds to manual bundling.
If you add a configured port to a
link aggregation, the port adopts
the configuration of the link ag-
gregation. If you take the port out
of the link aggregation, the set-
tings of the port are reset to the
factory settings.
Summary of Contents for SCALANCE XM-400
Page 882: ......
