
Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
192
Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 ... 4094
vlan-id
Number of the addressed VLAN
2 ... 4094
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you address several VLANs, you must insert a blank before and after the hyphen, for
example
no interface range vlan 5 - 10
.
Result
The VLANs have been removed from the specified interface area.
Further notes
With the
interface range
command, you can put several interfaces or VLANs together to be
able to configure them together.
6.1.2.3
map protocol
Description
With this command, you assign a protocol to a protocol group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
map protocol
{ip | novell | netbios | appletalk | other <aa:aa>}
enet-v2 protocols-group <Group id integer(1-100)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
ip
Internet Protocol v4
HEX 08:00
novell
Novell Netware protocol
HEX 81:38
netbios
Netbios via TCP/IP
HEX f0:f0
Summary of Contents for SCALANCE XM-400
Page 882: ......