Configuration
3.2 Load and Save
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
114
Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
loadsave
Result
You are now in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Further notes
You exit the LOADSAVE configuration mode with the
exit
command.
3.2.5
Commands in the LOADSAVE configuration mode
This section describes commands that you can call up in the LOADSAVE configuration
mode.
In the Global Configuration mode, enter the
loadsave
command to change to this mode.
You display the valid file types for the commands in the LOADSAVE Configuration mode
with the global command
show loadsave tftp
.
●
If you exit the LOADSAVE configuration mode with the
exit
command, you return to the
Global Configuration mode.
●
If you exit the LOADSAVE configuration mode with the
end
command, you return to the
Privileged EXEC mode.
For information on the file types , refer to this list (Page 109).
3.2.5.1
delete
Description
With this command, you call up the possible files or delete a specific file.
Summary of Contents for SCALANCE XM-400
Page 882: ......
