Rinse aid
en
11
Using special salt
Always refill with special salt
immediately before switching on the
appliance. This ensures that overrun
special salt solution is immediately
washed out and does not corrode the
rinsing tank.
1.
Open the screw-type cap of the
compartment
1B
.
2.
Fill the tank with water (only required
when switching on the appliance for
the first time).
3.
Then add dishwasher salt
(not table
salt or tablets)
.
The water is displaced and runs out.
As soon as the salt refill indicator
`
on the fascia is lit, top up the salt.
* depending on model
Using detergents with salt
component
Detergents with salt component
If combined detergents with a salt
component are used, salt can usually be
omitted up to a water hardness of
21° dH (37° fH, 26° Clarke, 3.7 mmol/
l). If the water hardness is over 21° dH,
special salt must be used.
Switching off salt refill
indicator/water softening
system
Switching off water softening system
If the salt refill indicator
`
is impaired
(e.g. when using combined detergents
containing salt component), it can be
switched off.
ヽ
Proceed as described under
“Adjusting the water softening
system” and set the value to
•
:
‹‹
.
The water softening system and salt
refill indicator are now switched off.
m
Caution
Never fill the salt dispenser with
detergent. You will destroy the water
softening system.
,
Rinse aid
R
in
se
aid
As soon as the rinse-aid refill
indicator
X
is lit on the fascia, there
is still a rinse-aid reserve of 1-2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
Summary of Contents for SC73E610TI
Page 2: ...6WDUW 5HVHW VHF ...
