Siemens SC73E610TI, Operating Instructions Manual

Page: 10 / 40

en Water softening system/Special salt
10
+
Water softening
system/Special salt
W ater so ften in g sy stem /S p ecial salt
To ensure good washing results,
the dishwasher requires soft water, i.e.
containing low amounts of lime,
otherwise white limescale will be
deposited on the utensils and inner
container.
Tap water above 1.2 mmol/l must be
softened. The water is softened with
special salt (regeneration
salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt
depends on the degree of hardness of
your tap water (see table).
Setting
The amount of salt dispensed can be
set from
•
:
‹‹
to
•
:
‹ˆ
.
Salt is not required at the set
value
•
:
‹‹
.
1. Find out about the hardness value of
your tap water. Your water utility
company will help you with this.
2. Set value can be found in the water
hardness table.
3. Close the door.
4. Switch on ON/OFF switch
(
.
5. Press and hold down the START
button
8
.
6. Rotate programme selector
0
until
•
:
‹
... is indicated on the digital
display
@
.
7. Release button.
The factory set value
•
:
‹…
is lit on
the digital display
@
.
To change the setting:
1.
Rotate programme selector
0
until
the required value is indicated on the
digital display
@
.
2. Press START button
8
.
The set value is saved.
Water hardness table
‡ ¯¯
‡ ¯³
‡ ¯›
‡ ¯´
‡ ¯ž
‡ ¯‚
‡ ¯±
‡ ¯Å
:DWHU
KDUGQHVV
YDOXH
ƒ&ODUNH
VRIW
PHGLXP
KDUG
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
PPROO
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
6HWYDOXH
RQWKH
PDFKLQH
+DUGQHVV
UDQJH
KDUG
KDUG
PHGLXP
PHGLXP
VRIW