Installing the Device
2.1 General Procedure
a tool, lock and key, or other means of security, and controlled by the authority re-
sponsible for the location.
2.1
General Procedure
The general procedure for installing the device is as follows:
NOTICE
The user is responsible for the operating environment of the device, including main-
taining the integrity of all protective conductor connections and checking equip-
ment ratings. Make sure to review all operating and installation instructions before
commissioning or performing maintenance on the device.
1. Review the relevant certification information for any regulatory requirements.
For more information, refer to
.
2. Review the
RUGGEDCOM RX1500 Series Modules Catalog
for special installation
or regulatory requirements related to the modules installed in the device. In the
case of cellular modem line modules, this includes antenna installation and reg-
ulatory requirements.
3. Mount the device.
4. Connect the failsafe alarm relay.
5. Connect power to the device and ground the device to safety Earth.
6. Connect the device to the network.
7. Configure the device.
2.2
Unpacking the Device
When unpacking the device, do the following:
1. Inspect the package for damage before opening it.
2. Visually inspect each item in the package for any physical damage.
3. Verify all items are included.
NOTICE
If any item is missing or damaged, contact Siemens for assistance.
2.3
Mounting the Device
The RUGGEDCOM RX1512 is designed for maximum mounting and display flexibility.
It can be equipped with connectors that allow it to be installed in a 35 mm (1.4 in)
DIN rail, or directly on a panel.
6
RUGGEDCOM RX1512
Installation Manual, 07/2019, C79000-G8976-1057
