RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting an IKE Algorithm
627
1
4
2
3
Figure 731: Key Settings Form
1.
Cipher Algorithm Box
2.
Hash Method Box
3.
Mod Group Box
4.
Add Button
4. Configure the following parameter(s) as required:
Parameter
Description
Cipher Algorithm
Synopsis:
3des, aes, aes256, aes192, aes128, any
The cipher algorithm. The default value is '3des' or 'aes' unless overwritten by the
default connection setting.
Hash Method
Synopsis:
sha1, md5, any
The hash method. The default value is 'sha1' or 'md5' unless overwritten by the default
connection setting.
Modpgroup
Synopsis:
modp1024, modp1536, modp2048, modp3072, modp4096, modp6144,
modp8192, any
The Modular Exponential (MODP) group. The default value is 'modp1024' or 'modp1536'
unless overwritten by the default connection setting.
5. Click
Add
to create the new algorithm.
6. Click
Commit
to save the changes or click
Revert All
to abort. A confirmation dialog box appears. Click
OK
to proceed.
7. Click
Exit Transaction
or continue making changes.
Section 5.28.7.3
Deleting an IKE Algorithm
To delete an algorithm for the Internet Key Exchange (IKE) protocol, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
tunnel
»
ipsec
»
connection
»
{connection}
»
ike
, where
{connection}
is the name of the
connection. The
Algorithm
table appears.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...