Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
526
Configuring Match Rules
Section 5.21.6.7
Configuring Match Rules
To configure match rules for a route map filter entry, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
routing
»
dynamic
»
ospf
»
filter
»
route-map
»
{tag}
»
entry
»
{number}
»
match
, where
{tag}
is the tag for the route map filter and
{number}
is the sequence number for the entry. The
Match
Address of Route
,
Match Nexthop of Route
,
Match Advertising Source Address
and
Match
forms
appear.
1
Figure 606: Match Address of Route Form
1.
Prefix List List
1
Figure 607: Match Nexthop of Route Form
1.
Prefix List List
1
Figure 608: Match Interface Form
1.
Interface Name List
3. On the
Match Address of Route
form, configure the following parameters as required:
Parameter
Description
Prefix List
The prefix list name.
4. On the
Match Nexthop of Route
form, configure the following parameters as required:
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...