Installing the Device
2.5.5 Connecting WLAN Antennas
2. If required, connect the optional lightning arrestor, line amplifier or bandpass fil-
ter to the antenna.
4
1
1
3
3
5
2
6
5
1
Drain Wire
2
RUGGEDCOM RX1400
3
Shielded Coaxial Cable
4
Lightning Protector, Line Amplifier or Bandpass Filter
5
Ground Wire
6
GPS Antenna
Figure 2.7
Antenna and Lightning Protector Assembly (Optional)
3. Using shielded coaxial cables, connect the antenna assembly to the
ANT2
port
on the device.
2.5.5
Connecting WLAN Antennas
Install a single WLAN antenna for Single-Input Single-Output (SISO) or dual antennas
for Multiple-Input Multiple-Output (MIMO).
To install a WLAN antenna, do the following:
1. Select an appropriate antenna. For a list of available WLAN antennas, refer to
"Available Antennas (Page 14)"
2. Mount the antenna to a pole or wall in an area that provides good signal cover-
age and is away from any signal noise emanating from other communications
equipment.
20
RUGGEDCOM RX1400
Installation Manual, 09/2019, C79000-G8976-1103-13
