Siemens RUGGEDCOM RS900GP, Installation Manual

Page: 31 / 46

RUGGEDCOM RS900GP
Installation Guide
Chapter 4
Communication Ports
Fiber Optic Ethernet Ports 21
Section 4.3
Fiber Optic Ethernet Ports
Optional 100Base-FX, 1000Base-SX and 1000Base-LX fiber optic Ethernet ports are available for ports 9 and 10
with either LC (Lucent Connector) and SC (Standard or Subscriber Connector) connectors. Make sure the Transmit
(Tx) and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
Available Ports
2 1
Figure 17: SC Connector
1. Tx Connector 2. Rx Connector
2 1
Figure 18: LC Connector
1. Tx Connector 2. Rx Connector
LEDs
Each port features an LED that indicates its link/activity state.
1 1
Figure 19: LED for Fiber Optic Ethernet Ports
1. Link/Activity LED
State Description
Green (Solid) Link established
Green (Blinking) Link activity
Off No link detected
Specifications
For further specifications, refer to Section 5.5, “Fiber Optic Ethernet Port Specifications” .
Section 4.4
SFP Transceivers
The RUGGEDCOM RS900GP supports up to two Small Form-Factor Pluggable (SFP) transceiver sockets, which are
compatible with a wide array of SFP transceivers available from Siemens.
LEDs
Each socket features an LED that indicates its link state.