Siemens RUGGEDCOM RS1600F, Installation Manual

Page: 17 / 40

Installing Device
2.2 Connecting Power
To mount the device to a panel, do the following:
1. Place the device against the panel and align the adapters with the mounting
holes.
RS2 32P ORT
FAI LSA FE
THI SD EVI CE COM PLI ES WIT HP ART 15O F
THE FCC RUL ES. OPE RAT ION IS SUB JEC TT O
THE FOL LOW ING TW OC ON DIT ION S:(1 )TH IS
DEV ICE MAY NOT CAU SE HAR MFU L
INT ERF ERE NCE ,A ND (2) THI SD EVI CE MUS T
ACC EPT AN YIN TER FER EN CE REC EIV ED,
INC LUD ING INT ERF ERE NCE THA TM AY CAU SE
UN DES IRE DO PER ATI ON. POW ER SUP PLY 2
-/N +/H
POW ER SUP PLY 1
-/N +/H
1
1 2
1
Screw
2
Panel/DIN Rail Adapter
Figure 2.3 Panel Mounting
2. Install the supplied screws to secure the adapters to the panel.
2.2 Connecting Power
The RUGGEDCOM RS1600F supports single or dual redundant high AC, high DC
and/or low DC power supplies. The use of two power modules is recommended to
provide redundancy and load balancing.
The RUGGEDCOM RS1600F can be equipped with either a screw-type or pluggable
terminal block, which provides power to both power supplies. The screw-type
terminal block is installed using Philips screws and compression plates, allowing
either bare wire connections or crimped terminal lugs. Use #6 size ring lugs for
secure, reliable connections under severe shock or vibration.
IMPORTANT
• For maximum redundancy in a dual power supply configuration, use two
independent power sources.
8
RUGGEDCOM RS1600F
Installation Manual, 01/2021, C79000-G8976-1014-03