Siemens RUGGEDCOM ROX II, User Manual

Page: 568 / 798

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
522 Viewing the Status of Dynamic OSPF Routes
Parameter Description
opaque-lsa Enables the Opaque-LSA capability (RFC2370).
passive-default Synopsis: { true, false }
Default: true
Default passive value for new interface.
refresh-timer { refresh-timer } Synopsis: A 16-bit unsigned integer between 10 and 1800
Default: 10
The refresh timer.
router-id { router-id } Synopsis: A string 7 to 15 characters long
The Router ID for OSPF.
3. Configure prefix list filters. For more information, refer to Section 13.9.4.3, “Adding a Prefix List” .
4. Configure areas. For more information, refer to Section 13.9.5.2, “Adding an Area” .
5. Configure route map filters. For more information, refer to Section 13.9.6.3, “Adding a Route Map Filter” .
6. Configure redistribution metrics. For more information, refer to Section 13.9.8.2, “Adding a Redistribution
Metric” .
7. Configure interfaces. For more information, refer to Section 13.9.9.2, “Configuring a Routing Interface” .
8. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.9.3
Viewing the Status of Dynamic OSPF Routes
To view the status of the dynamic OSPF routes configured on the device, type:
show routing status ospf route network
If OSPF routes have been configured, a table or list similar to the following example appears:
ruggedcom# show routing status ospf route network | tab
ID DISCARD INTER AREA COST AREA HOW
---------------------------------------------------------------------------------
192.168.1.0/24 no intra area 10 0.0.0.0
directly attached to fe-1-2
192.168.2.0/24 no intra area 10 0.0.0.0
directly attached to fe-1-4
This list provides the following information:
Parameter Description
id Synopsis: A string
Network Prefix.
destination Synopsis: A string
Destination (network or discard).
path-type Synopsis: A string
Path type (inter-area or intra-area).
cost Synopsis: A string
Cost.