Siemens RUGGEDCOM ROX II, User Manual, Page: 238 / 798

Chapter 6
Security
RUGGEDCOM ROX II
CLI User Guide
192 Deleting a Zone
1. Make sure the CLI is in Configuration mode.
2. Add the zone by typing:
security firewall fwconfig firewall fwzone zone
Where:
•
firewall
is the name of the firewall
• zone is the name of the zone
3. Configure the following parameter(s) as required:
Parameter Description
iptype { iptype } Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used, otherwise define IPv4 and
IPv6 rules for each type of addresses used.
type46 { type46 } Synopsis: { ip, ipsec, firewall }
Default: ip
Zone types applying to both IPv4 and IPv6: plain IP, firewall, or IPSec
type6 { type6 } Synopsis: { ipv6, ipsec, firewall }
Default: ipv6
Zone types are plain IPv6, firewall, or IPSec
type { type } Synopsis: { ipv4, ipsec, firewall }
Default: ipv4
Zone types are plain IPv4, firewall, or IPSec
description { description } Synopsis: A string
(Optional) The description string for this zone
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 6.9.9.3
Deleting a Zone
To delete a zone, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the zone by typing:
no security firewall fwconfig firewall fwzone name
Where:
•
firewall is the name of the firewall
•
name
is the name of the zone
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.