Siemens Rapidlab 1200, Operator'S Manual, Page: 306 / 448

8-12 Rapidlab 1200 Operator’s Guide: System Configuration
02087462 Rev. V
Define a Custom Panel
To define a custom panel, perform the following steps.
NOTE:
Custom panels can only be defined for patient samples.
1. At the Setup screen, select
Sample > Parameter Selection
.
Three columns display. The first column displays a Default button. The second and
third columns each display 3 sets of custom buttons.
2. Select a panel button from the second or third column.
You may select any of the panel buttons in any order.
A screen displays available parameters.
3. Select parameters.
The Microsample button displays at the top-right of the screen.
4. To select a custom panel for microsample analysis, select
Microsample
.
To select a normal panel, go to 5.
NOTE:
If Microsample is selected, parameters not available for microsample analysis
such as tHb and nBili do not display.
5. Select
Save
.
6. At the Parameter Selection at Analysis screen, verify that the panel button contains all
the parameters you selected.
Microsample panels display a µ character at the top-left of the panel.
Repeat steps 2 through 6 for all panels and sets you want to configure.
7. Select
Save
.
Select a Default Custom Panel
1. At the Setup screen, select
Sample > Parameter Selection
.
2. Select the first panel in the first column.
3. Select parameters.
The Microsample button displays at the top-right of the screen.
4. To select a custom panel for microsample analysis, select
Microsample
.
To select a normal panel, go to 5.
NOTE:
If Microsample is selected, parameters not available for microsample analysis
such as tHb and nBili do not display.
5. Select
Save
.
6. Select
Default
.