Siemens
Siemens
Siemens
Siemens
Siemens Industry
Industry
Industry
Industry
Industry,,,,, Inc.
Inc.
Inc.
Inc.
Inc.
Building
Building
Building
Building
Building T
TT
TTec
ec
ec
ec
echnologies Di
hnologies Di
hnologies Di
hnologies Di
hnologies Division
vision
vision
vision
vision
P/N 315-050636-1
Figure 1
PMI-2 User Interface
PARTIAL SYSTEM
DISABLED
POWER
AUDIBLES
ON
SILENCED
CPU FAIL
ALARM SUPERVISORY SECURITY TROUBLE
MENU
ESC
More
Info+
?
Person-Machine Interface
Installation Instructions
Models PMI-2
INTRODUCTION
The Model PMI-2 from Siemens Industry, Inc., is the user interface for the FireFinder-
XLS™ system. From the PMI-2 the operator can acknowledge events, control the
system notification appliance circuits and reset the system. Detailed information
about the nature and location of events can also be displayed.
The PMI-2 is used as the primary user interface in CAB1, CAB2 or CAB3
enclosures. The PMI-2 can also be used as a primary user interface in a
remote REMBOX2 or REMBOX4 enclosure.
The PMI-2 contains the site specific program as developed in Zeus. All
system logic and supervision is provided by the controller in the PMI-2.
The PMI-2 contains a full VGA LCD, Touch Screen and LEDs for display-
ing system status. An audible sounds when there are unacknowledged
events on the PMI-2. The display is surrounded by keys that are used to
control the displayed information and to navigate through these
screens. Keys are also provided to obtain help and to enter into the
menu features of the PMI-2. (Refer to Figure 1.)
On the back of the PMI-2 there are additional diagnostic displays to aid
in system troubleshooting. This is also where the PMI-2 address is set
and where the connection is made to Zeus for programming. (Refer to
Figure 2.)
For systems configured to provide Smoke Control (UUKL), refer to the
FireFinder XLS Control Panel System Manual, P/N 315-034853.
PRE-INSTALLATION
Additional labels are available for applications that require French (Canadian), Spanish,
or Portuguese (Brazilian) languages. These labels need to be ordered separately.
Refer to the table below for ordering information.
To apply labels, remove the backing from the labels and apply them to the PMI-2.
(Refer to Figure 3.)
