Siemens optiPoint 300 basic, Operation And Andministration Manual

Page: 61 / 90

Configuration and administration
61
Terminal reset
Telephone restart
A restart of the telephone unit may be necessary to incorporate
changes made by the administrator, for example. There are four
possibilities for the optiPoint 300 basic to be restarted:
– Power on restart
Unplug the power connector briefly, then reconnect it.
– Manual restart
Press simultaneously the keys 1, 7 and 3.
– Automatic restart
This is performed following a serious error or changes to
administrator settings.
– Restart by the HiPath web administrator
Restore factory default settings
You can restore your optiPoint 300 basic unit's factory default set-
tings at any time. Settings that have been changed with an admin-
istrator PIN can be reset in this way without having to enter the
PIN.
To restore the defaults, proceed as follows.
● Put telephone into idle mode
● Disconnect from network
● Pick up handset
● Press keys 2, 8 and 4 simultaneously
You will see the following display:
Once you have correctly entered the PIN and pressed
?
to con-
firm it, the factory default settings will be restored and your opti-
Point 300 basic unit restarted after reconnecting the net. Further
proceeding is described on pages 20, 21.
The default settings are listed in the Annex, on page 82.
– – – – – –
Enter the PIN (124816)
?
Press key