Siemens optiPoint 300 basic, Operation And Andministration Manual

Page: 21 / 90

Installation
21
HiPath system without DHCP server
If there is no DHCP server in the environment, you will have to
manually enter an IP address and other required parameters us-
ing the keypad.
Press the
?
key (all other keys will be disabled).
You will hear a beep confirming successful completion. For five
seconds, the display will show:
After that, the telephone goes into idle mode.
You may break off initialisation at any time by pressing the
h
key.
Any settings previously entered will be cancelled, and you will be
returned to the point at which you were asked to enter the admini-
strator's PIN.
If an SNTP server is located within the HiPath environment, the te-
lephone unit will automatically get the correct date and time from
it. Otherwise, you must manually enter this information, as descri-
bed in the chapter entitled "Configuration and administration".
– – – – – – – – – – –
–
– – –
Flashing programming
and initialisation symbols,
flashing dash line
– – – – – –
Enter the administrator's
PIN
?
Confirm your input
1P 132 075 100 169
Enter the IP address
?
Confirm your input
P1 120 115 200 003
Enter the subnet mask IP
?
Confirm your input
P2 _
Enter the telephone num-
ber to be used
?
Confirm the telephone
number and exit the menu
P PA55Ed
Initialisation successful
12 – 03 – 00 12 – 34
Idle mode