en
Operating the appliance
6
1
Operating the appliance
Operating the appliance
These instructions apply to several appliance variants.
It is possible that individual features are described
which do not apply to your appliance.
Note:
Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel model 1 and 2
Setting the fan
Switching on
Pull out the filter pull-out. The fan starts at the selected
level.
Press buttons 1, 2 or 3 in order to change the fan
strength.
Switching off
Slide the filter pull-out in as far as the limit stop.
Note:
When you pull out the filter pull-out again, the fan
starts up at the fan speed that was last selected.
Control panel model 3
Setting the fan
Switching on
Pull out the filter pull-out and press the
#
button. The
fan starts at setting 2.
Press the + or - button to change the fan strength.
Switching off
Press the
#
button. Slide the filter pull-out in.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button until all of the LEDs in the display
light up. The intensive setting is activated.
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
The run time is limited. The fan is then automatically
reduced to a lower fan setting. You can switch back
manually at any time.
Fan run-on time
If you slide in the filter pull-out, the run-on time will be
activated for as long as the extractor hood is operating.
After approx. 10 minutes, the fan switches off
automatically.
Lighting
The lighting can be switched on and off independently
of the ventilation.
Press the
A
button.
Explanation
0,
A
Light on/off
1
Fan speed 1
2
Fan speed 2
3
Fan speed 3
Explanation
<
Light on/off
#
Fan on/off
-
Reduces the fan speed
+
Increases the fan speeds/intensive setting
