Operating instructions
Landis & Staefa REV11…
REV11… - the temperature controller that allows you to set the ideal room temperature at the
time you want. There are two switching patterns available that can be set to suit your specific
needs. You can either rely on the factory settings or make settings tailored to your personal
needs.
Setting slider
Changing the setting values
Display
Settings
Time of day
Room temperature
(measured)
Time of day
Remote operation active
(if connected)
Standby
Normal temperature
Heating on
Economy temperature
Replace batteries
°C
1.5V 'AA'
1.5V 'AA'
Operation
Continuous
normal temperature
Continuous
economy temperature
Standby
with frost protection
Operating mode
selector
Change
between normal and
economy mode up to the
next switching point
Warmer/colder setting
valid up to the next
switching point
(increments of 0.2 ºC,
± 4 ºC max.)
24-hour mode A
with 2 heating periods
Auto
Run
A1
A2
A3
A4
B1
B2
Operating
position
Auto
Run
Economy
temperature
Normal
temperature
Switching times
B1...B2
B1
B2
Switching times
A1...A4
A1
A2
A3
A4
2222Z11E
24-hour mode B
with 1 heating period
A
B
Commissioning with quick startup
The controller is supplied with factory-set switching patterns, switching times and
temperatures. To commission it, proceed as follows:
1.5V 'AA'
1.5V 'AA'
Remove the black transit tabs from the two batteries. Check to see if the battery
holder is in its correct position. The controller switches itself on.
Move the setting slider to the time position.
Press buttons to set the correct time of day.
Auto
Run
Move the setting slider back to position on the right, because only that position
allows you to close the cover.
A
Select the required operating mode with the operating mode selector (e.g.
A
).
Fold up the operating instructions again, place them back into the cover and close the cover
again.
Do you want to use automatic
operation?
If that is the case, set the operating
mode selector to one of the
following positions:
A
You use the 24-hour setting A with
two heating periods.
B
You use the 24-hour setting B with
one heating period.
Do you require continuous normal
temperature?
Move the operating mode selector
to «Normal temperature». This
ensures continuous heating to the
normal temperature. The display
shows
.
Do you require continuous economy
temperature?
Move the operating mode selector
to «Economy temperature». This
ensures continuous heating to the
economy temperature. The display
shows
.
Do you require continuous standby
with frost protection?
Move the operating mode selector
to «Standby». In that case, heating
is provided only when the room
temperature falls below the preset
frost protection limit (5 °C). The
display shows
.
Do you feel too warm or too cold?
°C
By pressing these buttons, you
increase or decrease the actual
room temperature in increments of
0.2 °C by a maximum of
±
4°C. The
display first shows the newly
selected temperature and then the
actual value again. These
changes are valid only up to the
next switching point.
If, as a
result of the factory settings, you
always feel either too warm or too
cold, you should readjust the
temperature
or
to suit your
needs
.
