Siemens IQ300 SN93HX60CG, User Manual

Page: 31 / 60

Basic operation
en
31
Removing tableware
WARNING
Risk of injury!
Hot tableware can cause burns to the
skin. When hot, tableware is sensitive
to shock, may crack and can result in
injury.
▶
When the programme has ended,
do not empty the appliance until
the tableware has cooled down for
a while.
1.
To prevent water dripping on the
tableware, unload it starting at the
bottom and working up.
2.
Check the washing tank and ac-
cessories for soiling and clean if
necessary.
→
"Cleaning and servicing",
Page 37
Basic operation
Basic operation
Basic operation
Opening appliance door
1.
If the electric childproof lock is not
activated, press on the upper
middle section of the appliance
door.
2.
If the electric childproof lock is ac-
tivated, press on the upper middle
section of the appliance door twice
with a short interval in between.
a
The appliance door will open auto-
matically.
Switching on the appliance
▶
Press ⁠.
The Eco 50° programme is set by
default.
The Eco 50° programme is an es-
pecially environmentally friendly
programme and ideal for normally
soiled tableware. It is the most effi-
cient programme for the combina-
tion of energy/water consumption
for this type of tableware and evid-
ences conformity with the EU Eco-
design Directive.
If you do not perform any actions
on the appliance for 10 minutes,
the appliance will automatically
switch off.
Setting a programme
To adjust the wash cycle to the soil-
ing level of the tableware, select a
suitable programme.
▶
Press the right programme button.
→
"Programmes", Page 17
a
The programme is set and the pro-
gramme button flashes.
a The remaining running time of the
programme appears on the dis-
play.
Setting additional functions
You can set additional functions to
complete the washing programme
selected.
Note:
The additional functions which
can be used depend on the pro-
gramme selected.
→
"Programmes", Page 17
▶
Press the button for the relevant
additional function.
→
"Additional functions", Page 19
a
The additional function is set and
the additional function button
flashes.
Setting timer programming
You can delay the start of the pro-
gramme by up to 24 hours.
1.
Press ⁠.
a "h:01" appears in the display.
2.
Use to set the required start
time for the programme.