Installing and connecting the device
3.4 Connecting the device
Industrial Flat Panel IFP1500, IFP1900, IFP2200, IFP1900 PRO, IFP2200 PRO, IFP1900 ETH, IFP2200 ETH
62
Operating Instructions, 07/2016, A5E31298376-AF
Note
Functional problem with USB port
If you connect an external device with a 230 V power supply to the USB port without using a
non-insulated installation, you may experience functional problems.
Use a non-insulated system design.
Excessive rated load on port
A USB device with too high a power load may possibly cause functional problems.
Observe the values for the maximum load of the USB interface. You will find the values in
the section "Technical specifications" (Page 98)".
Front USB of the Touch/Key version
Note
Ensuring degree of protection IP65
When you loosen the sealing cover above the USB port to connect a USB component, the
degree of protection IP65 is no longer guaranteed for the device.
3.4.7
Securing the cables
Use cable ties to secure the connected cables to the selected fixing elements for strain relief.
Make sure that the cables are not crushed by the cable tie.
The figure below shows the fixing elements of the IFP1500 Touch.
The figure below shows the fasteners of the IFP1900 PRO.
