Siemens HP243521M, Instruction Manual

Page: 12 / 24

12
Before using the oven for the first time
In this section, you can find out what you must do before using
your oven or gas hob to prepare food for the first time. First
read the section on Safety information .
Setting the time of day
When you connect the power for the first time, the
x
symbol
lights up.
1.
Make sure that the x is flashing in the display.
2.
Press the 0 button.
The display goes dark.
You can use the oven clock as a timer. How to set the timer is
explained on the following pages.
Caution!
The clock runs independently of the lower gas burner and gas
grill.
The oven clock can be used as a timer.
The clock runs independently of the oven.
The clock has no effect on the gas supply to the lower gas
burner and grill burner. The gas supply is interrupted if the
switch is turned off.
Heating up the oven
To remove the new cooker smell, heat up the oven when it is
empty and closed. Ensure that no packaging material has been
left in the cooking compartment.
Setting procedure for the lower gas burner
Example in the picture: Heat at 270 °C
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Open the main gas supply to the appliance. Connect the plug
in the socket. Open the oven door.
3.
Push in the switch for the lower gas burner and turn it to
270 °C.
4.
While holding the switch for the oven's lower gas burner
depressed, press the ignition button
8
.
5.
The gas escaping from the oven's lower gas burner is ignited
using the ignition button. To activate the safety pilot, press
and hold the lower gas burner on the oven for 10 seconds.
6.
Look through the inspection port to make sure that the flame
is lit. If it is not, repeat the process from step 3.
7.
Close the oven door slowly.
8.
Turn off the switch for the lower gas burner after 30 minutes.
Setting procedure for the gas grill in the oven
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Open the main gas supply to the appliance. Connect the plug
in the socket.
3.
Insert the protective plate into the groove under the control
panel.
The protective plate is inserted with the longer edge at the
front and the curvature pointing downwards.
Secure the protective plate in the groove underneath the
control panel using the retainers.
Make sure that the protective plate is engaged in the
retainers. If the protective plate cannot be pulled out, it is
correctly engaged. You can now use the protective plate
safely. Otherwise, insert the protective plate into a groove at a
slightly higher angle and make sure that it engages in the
retainers.
4.
Close the oven door so that it touches the protective plate.
5.
Press the function selector and turn it clockwise to the
#
grill setting.
6.
Keeping the function selector pressed, push the
8
ignition
button.
7.
The gas escaping from the gas grill is ignited using the
ignition button. To activate the safety pilot, press and hold the
function selector for 10 seconds.
8.
Check that the flame is lit. If it is not, repeat the process from
step 5.
9.
After 30 minutes, switch off the function selector. Once the
oven has cooled down, remove the protective plate again.
Cleaning the accessories
Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.