HiPath Cordless Office
Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
11-2
HiPath 3000/5000 V9, Service documentation
cordless.fm
Introduction
11.1
Introduction
For HiPath 3000 V1.2 and later, HiPath Cordless Office can be used on all systems of this prod-
uct line.
Direct connection
The BS3/1 (S30807-H5482-X) and BS4 (S30807-U5491-X) base stations can be connected di-
rectly to the U
P0/E
interfaces on the central control boards in the HiPath 3550, HiPath 3350, Hi-
Path 3500, and HiPath 3300. The connection must be made via one U
P0/E
interface each. A
mix of base stations of types BS3/1 and BS4 is supported.
A BS3/S (X30807-X5482-X100) single-cell base station can be used to ensure the operation
of a maximum of one base station at the U
P0/E
interfaces on central control boards in the HiPath
3550, HiPath 3350, HiPath 3500, and HiPath 3300. In this case, it is not possible to expand with
additional base stations.
However, base stations cannot be simultaneously connected to the SLC16N board and the
CBCC within one HiPath 3550 system.
Connecting cordless boards
Base stations can be connected to the U
P0/E
interfaces of the following cordless boards:
●
in HiPath 3550
●
in HiPath 3800
The base stations BS3/1 (S30807-H5482-X), BS3/3 (S30807-H5485-X), and BS4 (S30807-
U5491-X) may be used in mixed mode on the above cordless boards.
You can install up to four SLCN boards in HiPath 3800. All four boards provide full cordless
functionality (roaming and seamless connection handover) because the radio fields on the
cordless boards are synchronized within a single system (see Section 11.5).
The HiPath 3000 product line does not currently support the network-wide handover feature.
>
The base stations BS3/1 (S30807-H5482-X), BS3/3 (S30807-H5485-X), and BS3/S
(X30807-X5482-X100) are being phased out and may no longer be ordered. You
must use the successor product BS4 (S30807-U5491-X) instead of the types
named.
You can still operate the base stations listed in HiPath 3000. Base stations BS3/1,
BS3/3, and BS4 can also be used in mixed mode.
>
The SLC16 board (S30810-Q2922-X) is no longer supported in HiPath 3000/5000
V6.0 or later.
Summary of Contents for HiPath 3000 Series
Page 1252: ......
