Boards for HiPath 3000
Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
3-130
HiPath 3000/5000 V9, Service documentation
boards.fm
Peripheral boards
3.3.11
SLAD4, SLAD8, SLAD8R
Introduction
From HiPath 3000/5000 V6 R4 and V7 R4 or higher the following boards can be used to con-
nect analog stations (analog telephones, fax group 3 etc.):
●
SLAD4 (Subscriber Line Analog with DuSLIC) S30810-H2956-X100 – for HiPath 3550 and
HiPath 3350
●
SLAD8 (Subscriber Line Analog with DuSLIC) S30810-H2956-X200 – for HiPath 3550 and
HiPath 3350
●
SLAD8R (Subscriber Line Analog with DuSLIC Rack) S30810-K2956-X300 - for
HiPath 3500 and HiPath 3300
The SLAD boards are compatible successor modules for the following boards:
●
4SLA (S30810-Q2923-X200)
●
8SLA (S30810-Q2923-X100)
●
8SLAR (S30810-K2925-Z).
These are being phased out and can no longer be ordered.
Main features
A DTMF code receiver is available for each analog interface (permits DTMF dialing at analog
telephones). This guarantees that all analog terminals connected are fully accessible.
These boards support calling name identification presentation (CLIP).
The connection of external extensions via OPS (Off-Premises Station) signaling is supported.
Ring voltage is generated by the power supply unit of the relevant system (
for SLAD4
for SLAD8R). Please refer to Section 2.8 for information on how to set
the country-specific ring frequency.
>
NOTE
Danger of damage to property due to surge voltage. The required lightning protec-
tion measures must be taken for this board, see Section 2.1.2, “Lightning Protec-
tion”.
Summary of Contents for HiPath 3000 Series
Page 1252: ......
