snmpd.fm
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
E-1
Nur für den internen Gebrauch
Notes for Editing the File snmpd.cnf
Introduction
E
Notes for Editing the File snmpd.cnf
E.1
Introduction
The SNMP parameters required for HiPath 5000 are defined when installing the FM Reporting
Client (SNMP Master Agent). This refers to the trap destinations and the names of the HiPath
Fault Management desktop communities.
The FM Reporting Client does not have its own user interface. The SNMP parameters defined
during installation may only be changed by uninstalling and then reinstalling the FM Reporting
Client.
Users with sufficient knowledge of SNMP can change trap destinations and community names
by editing the file snmpd.cnf. The file can be found in the installation directory of the FM Re-
porting Client.
E.2
Trap Destination
Procedure for sending a trap
1.
Testing of the
snmpNotifyEntry
entries.
2.
A trap is sent for all with
snmpNotifyTag == snmpTargetAddrTagList
.
a)
Only one
snmpNotifyEntry
should exist.
b)
The
snmpNotifyTag
of this entry should be used in all
snmpTargetAddrEntries
.
3.
In addition, there must be an entry with
snmpTargetAddrParams == snmpTargetParamsName
.
snmpNotifyEntry <snmpNotifyName> <snmpNotifyTag> <snmpNotifyType>
<snmpNotifyStorageType>
●
snmpNotifyName
Any unambiguous identifier for the entry.
String with 1-32 characters.
>
The following notes on editing the file
snmpd.cnf
are intended exclusively for users
with sufficient knowledge of SNMP.
Note: The syntax of entries in the FM Reporting Client configuration file (SNMP mas-
ter agent) is appended to the element description in the SNMP-TARGET-MIB (RFC
3413 – Chapter 4, cf.
Summary of Contents for HiPath 3000 Series
Page 1252: ......
