Siemens HiPath 1120, Programming Manual

Page: 57 / 180

Programming an Extension
57
Step by Step
= No Caller ID (default)
= DTMF prior to ringing
= DTMF during ringing
= FSK prior to ringing
= FSK during ringing
Enter the next analog extension number
or
Press this key.
Initial state for Programming Mode.
Electronic Lock Password Reset
If it occurs that an extension’s user forgets the
password used to block the extension, the password
can be reset to the system’s default (default password
is 0000).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 12/102).
Enter the next extension number
or
Initial state for Programming Mode.
Timeout for Call Forwarding -
No Answer
This feature specifies a timeout for the First Attendant
to answer an incoming call. If the call is not answered,
it is forwarded to a Second Attendant, as programmed
(see Call Forwarding - No Answer in the Manual do
Usuário).
Required:
Programming Mode must be active (*95
31994).
0
1
2
3
4
#
2 6
A blocked extension can only make internal calls
using the System Speed Dialing phonebook
(abbreviated numbers).