Siemens HB75AA.50W, Instruction Manual

Page: 13 / 24

13
Before self-cleaning
Remove ovenware and unsuitable accessories from the
cooking compartment.
Clean the oven door and the along the edges of the cooking
compartment in the area around the seal. Do not clean the seal.
ã=
Risk of fire!
Loose food residues, grease and meat juices may catch fire.
Wipe the cooking compartment and the accessories that are to
be cleaned at the same time with a damp cloth.
Cleaning accessories at the same time
You can clean enamelled accessories without anti-stick coating
at the same time, e.g. the universal pan, at level 2. Always only
clean one accessory at a time.
Non-enamelled accessories, e.g. the wire rack, are not suitable
for the self-cleaning programme. Remove them from the
cooking compartment.
ã=
Risk of serious damage to health.!
Never clean non-stick baking trays and baking tins at the same
time using the self-cleaning programme. High temperatures
damage the non-stick coating and poisonous gases are
released.
Making settings
When you have selected a cleaning level, set the oven.
1.
Set the function selector to x Self-cleaning.
2.
Use the temperature selector to set the cleaning level.
The display shows the time at which self-cleaning will end and
the N arrow is next to the y symbol. Self-cleaning starts after a
few seconds. You can see the time counting down and the N
arrow is next to the x symbol. The y symbol goes out.
The oven door locks shortly after the programme starts. The H
symbol lights up in the display. The oven door cannot be
opened again until the H symbol goes out.
Self-cleaning has finished
0:00 is shown in the display. The oven stops heating. Turn the
function selector to the off position. The oven switches off. The
oven door cannot be opened again until the H symbol goes
out.
Changing the cleaning level
Once the programme has started, you can no longer change
the cleaning level.
Cancelling the self-cleaning programme
Turn the function selector to the off position. The oven switches
off. The oven door cannot be opened again until the H symbol
goes out.
Setting a later end time
The end time of the self-cleaning programme can be delayed.
In this way, self-cleaning can run overnight, for example, so that
you can use your oven during the day.
Make the settings as described in steps 1 and 2. Before the
oven starts, use the
@
or
A
button to set a later end time.
The oven switches to standby. The display shows the time at
which self-cleaning will end and the
N
arrow is next to the
y
symbol. When self-cleaning starts, you can see the time
counting down and the
N
arrow is next to the
x
symbol.
The
y
symbol goes out.
After self-cleaning
Once the cooking compartment has cooled down, wipe out the
ash that has been left behind in the cooking compartment with
a damp cloth.
Care and cleaning
With good care and cleaning, your oven will remain clean and
fully-functioning for a long time to come. Here we will explain
how to maintain and clean your oven correctly.
Notes
■
Slight differences in the colours on the front of the oven are
caused by the use of different materials, such as glass,
plastic and metal.
■
Shadows on the door panel which look like streaks, are
caused by reflections made by the oven light.
■
Enamel is baked on at very high temperatures. This can
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
Cleaning agents
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
■
sharp or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Area Cleaning agents
Oven front Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
glass scrapers.
Stainless steel Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such residues.
Special stainless steel cleaning prod-
ucts suitable for warm surfaces are avail-
able from our after-sales service or from
specialist retailers. Apply a thin layer of
the cleaning product with a soft cloth.
Door panels Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Door cover Stainless steel cleaning agents (available
from our after-sales service or from spe-
cialist retailers):
Please observe the manufacturer's
instructions.