23
3.
Close the locking levers on the left and right-hand side fully
(figure D).
The appliance door is secured and can no longer be
removed.
4.
Close the appliance door.
Cleaning the door panels
To facilitate cleaning, you can remove the door panels from the
appliance door.
:
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
:
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note:
Before removing, make a note of the orientation in which
the door panel is fitted, so that it is not refitted the wrong way
round.
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and installing the appliance door).
2.
Unscrew the cover at the top left and right of the appliance
door and detach it (figure A).
3.
Lift the door panel and remove it (figure B).
Removing the intermediate panel
Before removing, make a note of the position in which the
intermediate panel is fitted, so that you do not refit it the wrong
way round later.
1.
Press the left and right-hand holders outwards.
2.
Lift the intermediate panel slightly and take it out.
Cleaning
Clean the door panels with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
1.
Insert the intermediate panel on the left and right into the
supports.
2.
Push the intermediate panel downwards in the retainers.
Fitting the door panel
1.
Slide in the door panel all the way.
2.
Put the cover back in place and screw it in.
3.
Refit the appliance door.
Cleaning the rails
The rails can be removed for cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Detaching the rails
Note:
Swing the front of the rail as far as possible (until you feel
resistance), because otherwise the appliance side panel may
become bent.
1.
Carefully press the front of the rail upwards until it becomes
detached, and release it from the holder at the side (fig. A).
2.
Detach the rail from the holder and remove it (fig. B).
3.
Clean the rails with washing-up liquid and a sponge/brush
or
Clean the rails in the dishwasher.
&
'
$
%
%
$
www.devicemanuals.eu/
