9
First steps
Gigaset SX670_SX675 isdn / EN-Master / A31008-xxxx-xxxx-x-xxxx / starting.fm / 7.11.07
Ve
rs
ion 4,
16
.09.
2005
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Place your fingertip in the cavity on the
casing and pull the battery cover
upwards.
Placing the handset in the base station
and registering
¤
Place the handset in the base station
with its
display facing upwards
.
The handset registers automatically. Reg-
istration can take up to 5 minutes. During
this time
Regstr.Procedure
appears in the
display and the name of the base station
flashes, e.g.
Base 1
. The handset will be
assigned the lowest unassigned internal
number (1–6).
This will appear in the display when regis-
tration is complete, e.g.
INT 1
. This means
that the number 1 has been assigned.
If the internal numbers 1–6 are already
assigned to other devices, the number 6 is
overwritten.
To charge the batteries, leave the handset
in the base station.
For questions and problems see page 69.
Headset socket
You can connect various headset types
(with 2.5 mm jack connector), including:
HAMA Plantronics M40, MX100 and
MX150.
A compatibility list of tested headsets is
available on the Internet at:
www.plantronics.com/productfinder.
Initial charging and discharging of
batteries
If the handset is activated, the flashing
battery icon
e
in the top right of the dis-
play indicates that the batteries are being
charged.
During handset operation, the battery
icon indicates the charge status of the bat-
teries (page 1). The correct charge level
can only be displayed if the batteries are
first fully charged
and
discharged.
¤
To do this, leave the handset in the
base station or charging cradle
contin-
uously
for
seven
hours.
Please note:
– Automatic registration is only possible
while no one is making calls using the base
station.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work, the
handset will have to be registered manually
(page 49).
– You can change the name of the handset
(page 51).
Please note:
– If the handset has turned itself off because
the batteries are flat and if it is then placed
in the charging cradle, it will turn itself on
automatically.
– Only place the handset in the base station
or charging cradle that is intended for it.
