14
First steps
Gigaset SL78H / EN-USA-CANADA / A31008-M2058-R301-2-6019 / starting.fm / 30.03.2010
V
e
rsion 4, 16.0
9
.2005
Display in idle status
Once the phone is registered and the time set, the idle
display is shown, as in this example. After successful reg-
istration, the following is displayed:
u
The strength of the signal between the base station
and handset:
– poor to good:
Ò Ñ i Ð
– no reception:
|
flashes
u
Battery charge status:
outside the charger
–
U
white: charged over 66 %
–
V
white: charged between 33 % and 66 %
–
e
white or red
*
: charged under 33 %
–
=
flashes red: battery almost empty (less than 10 minutes talktime)
in the charger
–
= e V U
white: battery is charging
*
red:
older firmware version, please update the handset’s firmware
Setting up area codes
Before you can return a call from the Calls list (
page 31), you must store the local
area code of the area in which your phone is being used. If your phone is in a mul-
tiple area code area, you must also store the extra codes for that area.
Local Area Code
v
¢
Ï
¢
Telephony
¢
Local Area Code
~
Enter the local area code.
§Save§
Press the Display key.
a
Press
and
hold
(idle status).
Extra Codes
v
¢
Ï
¢
Telephony
¢
Extra Codes
~
Enter the extra code.
§Save§
Press the Display key.
a
Press
and
hold
(idle status).
Repeat the above steps until all the extra codes have been entered for your area. A
maximum of five (5) extra codes can be stored.
Your phone is now ready for use!
Please note
In idle status, the calendar display can be switched on and off (
i
V
INT 1
Feb
14, 2009
Calls
Calendar
07:15am
