76
Setting the base
Gigaset S810-S810A / Grossbritannien / A31008-M2306-L101-1-7619 / registr_sett.fm / 18.03.2011
V
e
rsion 4.1, 21
.11.2007
Setting the base
The base settings are carried out using a reg-
istered Gigaset S810H handset.
Changing the base Gigaset
S810A ringtones
u
Volume:
You can choose between five volumes
(0–6; e.g., volume 3 =
Š
) and the "cre-
scendo" ringtone (6; volume increases
with each ring =
‡
).
u
Ringtones:
You can select a ringtone from a list of
pre-loaded melodies.
In idle status:
v
¢
Ï
¢
Audio Settings
¢
Ringtones (Base)
¤
You can enter data in the following fields:
r
Set volume.
s
Scroll to the next line.
r
Set melody.
§Save§
Press the display key to save the
setting.
Activating/deactivating
music on hold
v
¢
Ï
¢
Audio Settings
¢
Music on Hold
Press
§Change§
to activate or deactivate the
music on hold (
³
= on).
Repeater support
With a repeater, you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Prerequisite:
A repeater is registered.
v
¢
Ï
¢
System
¢
Repeater Mode
Press
§Change§
to activate or deactivate
repeater mode (
³
= on).
After activating or deactivating the
repeater, switch your handset off and
on again (
•
Please note
u
Eco Mode
/ Eco Mode+
and repeater support cancel each
other out, i.e., if you use a repeater,
you cannot use Eco Mode or
Eco
Mode+
.
u
Encrypted transmission activated at
the factory is deactivated when a
repeater is registered.
•